How to Fit and Adjust The Equestrian Leather Collar and Chain Leash

By Liebe Seele | Premium Japanese Leather BDSM Gear | Published: 2026-11-05

Category: How-to Guides

A step-by-step guide to sizing, fitting, and safely adjusting The Equestrian leather collar and chain leash for comfortable, controlled play.

Quick answer

Measure your neck snugly, choose a collar that leaves room for two fingers, and adjust The Equestrian so the chain leash clips at the front without twisting. Always test the fit with gentle tension before play.

Why the right fit matters for a leather collar and chain leash

A leather collar and chain leash works only when the collar stays put and the leash hangs cleanly. Too loose, and the collar can slide or rotate, making leash cues vague. Too tight, and you risk pinching or restricted breathing. The Equestrian uses a deep brown leather band with gold-style hardware, so getting the fit right also protects the leather from unnecessary stress at the buckle and D-ring.

When to adjust rather than resize

Adjustment is for fine-tuning comfort and control during a session; resizing is for a permanent mismatch. If you can slip more than two fingers under the band or the collar rotates freely, adjust the buckle position. If the band digs in even at the loosest setting, the collar is the wrong size and no adjustment will fix it. The Equestrian has a fixed leather band, so check your neck measurement before ordering rather than relying on adjustment alone.

Step-by-step: fit and adjust The Equestrian collar and chain leash

Measure the neck properly: Wrap a soft tape measure snugly around the base of the neck, then add about 1–2 cm (0.5–0.75 in) for comfort. Common mistake: measuring loosely over clothing or adding too much slack, which leads to an oversized collar. Write down the measurement and compare it to the collar’s size range before adjusting anything.
Set the buckle to a two-finger fit: Fasten the collar and slide two fingers flat under the band. You should feel light pressure but no pinching. If two fingers slide in easily, tighten one hole; if they don’t fit, loosen one hole. Checkpoint: the collar should not rotate more than a few degrees when you gently twist it.
Position the D-ring and attach the chain leash: Rotate the collar so the D-ring sits at the front center of the throat, then clip the gold-style chain leash to the D-ring. Common mistake: attaching the leash to a side ring or leaving the D-ring off-center, which makes leash tension pull unevenly. With the leash attached, step back and check that the chain hangs straight and the collar stays centered.
Test tension and movement: Apply gentle leash tension and ask your partner to turn their head and swallow. The collar should stay in place without digging in. Checkpoint: no redness, pinching, or restricted breathing. If any appear, loosen one hole and retest.
Do a final safety check before play: Confirm the buckle is fully engaged, the leash clip is closed, and the chain has no twists. Keep a safety word or signal agreed, and never leave a collared partner unattended. Common mistake: skipping the check after adjustment, when the buckle may not be fully seated. Recheck the fit at the start of every session, since leather can soften slightly with wear.

Product facts

The Equestrian: Leather Collar and Chain Leash: The Equestrian is a deep brown leather collar with chocolate accents and a gold-style chain leash. The chain leash adds weight and pull, so a secure collar fit matters more than with a lightweight strap.
The Equestrian: Leather Collar and Chain Leash